Landoll 2131 Wing Coulter Chisel Manuel d'utilisateur télécharger pdf (Page 37)

3-1

Chapter 3

Assembly Instructions

It is very important that your new 2131 Wing Coulter

Chisel be properly assembled, adjusted and lubricated

before use. Illustrations to assist with the assembly

process are provided in “Standard Specifications” on

page 2-1. They show proper shank and light mounting

bracket spacing. Illustrations in this section show proper

assembly procedures. Remove paint from grease fittings.

Replace any grease fittings that are damaged or missing.

Be sure to return screws, clips, etc., to their original

locations.

To insure alignment of assemblies, leave the nuts loose

until completion of final assembly. Use lock washers or

flat washers as specified. Spread all cotter pins.

After completion of final assembly, tighten all nuts

evenly to prevent misalignment, distortion or binding.

Tighten all screws and nuts to the recommended torques

(See Table 2-1 and Table 2-2.)



DANGER



WARNING



DANGER



CAUTION



CAUTION

Coulter blades are extremely sharp. Exercise

extreme care when working on or near coulter

blades. Do not allow coulters to roll over or fall

onto any body part. Do not allow wrenches to slip

when working near coulter blades. Never push

wrenches toward coulter blades. Do not climb

over machine above coulter blades. Failure to

stay clear of coulter blade edges can cause

serious personal injury or death.

Do not attempt to lift heavy parts (such as the

frame, coulter gangs, wheel lift, and pull hitch)

manually. Use a hoist or a forklift to move these

parts into position.

To prevent accidental lowering:

1. All hydraulically elevated equipment must be

locked out using the cylinder lockouts.

2. Lower equipment to the ground while

servicing or when it is idle.

Failure to take measures to prevent accidental

lowering may result in serious personal injury or

death.

Be sure to bleed the hydraulic system of all air in

lines after installation. Failure to bleed the system

of all air can result in improper machine

operation.

Incorrect adjustment of disc adjust rods will

cause permanent equipment damage.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 97 98

Commentaires sur ces manuels

Pas de commentaire

Landoll 2131 Wing Coulter Chisel Manuel d'utilisateur Page 37

Commentaires sur ces manuels

Produits connexes et manuels pour Machines spéciales Landoll 2131 Wing Coulter Chisel