Landoll 2131 Wing Coulter Chisel Manuel d'utilisateur télécharger pdf (Page 74)

3-38 F-721-0513 Edition

ASSEMBLY INSTRUCTIONS

Coil Tine Harrow Installation

See Figures 2-20 thru 2-22 for 3 Row Coil Tine Harrow

placement dimensions.

1. Install 2 hole support plate into coil tine harrow arm

assembly. Use (2) 3/4-10 x 3 hex head cap screws to

hold plate in place.

2. Slide coil tine harrow arm assemblies over rear frame

bar using chopper reel placement drawings (See

Figures 2-20 thru 2-22 and 3-31.)

3. Attach top plate to top of chopper reel arm assembly

using (4) 3/4-10 x 13 hex head cap screws. Slide arm

support tube and bottom plate onto 13” hex head cap

screws on underside of chopper reel arm assembly

and rear frame (See Figure 3-31.)

4. Evenly tighten the 3/4-10 x 13 hex head cap screws

first. Then tighten the front 3/4-10 x 2 hex head cap

screw. Tighten 3/4-10 x 3 hex head cap screws last,

but be sure to not overtighten. These screws need to

be snug.

5. Adjust spring to 21-1/2” (See Figure 3-32.)

6. Attach harrow arms to 3 row coil tine harrow

assembly using u-bolts, and 5/8-11 flange head

serrated nuts. The u-bolt will go through both the

harrow arm and harrow stiffener plate.

Figure 3-32: Coil Tine Arm Spring Adjustment

21-1/2”

2130-21-tine-2

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 97 98

Pas de commentaire

Landoll 2131 Wing Coulter Chisel Manuel d'utilisateur Page 74