Landoll 2131 Wing Coulter Chisel Manuel d'utilisateur télécharger pdf (Page 52)

3-16 F-721-0513 Edition

ASSEMBLY INSTRUCTIONS

Rigid Shear Shank and Shovel

Installation

1. Attach each shank assembly to each clamp

assembly using 3/4-10 x 4 hex head cap screws and

hex lock nuts in the top hole and 5/8-11 x 5-1/2 hex

head cap screw and hex lock nut in the lower hole

(See Figure 3-9.)

IMPORTANT

5/8 x 3/4 x 1-1/4 connex bushings shown in the

drawing are installed at the landoll corporation.

2. Install 2 x 1 x 18 spikes or 1/2 x 4 x 26 twisted

shovels onto shanks as follows:

a. Connect 2 x 1 x 18 spike to each shank using

1/2-13 x 3 hex head cap screws, flat washer (in

bottom hole only), split lock washers, and hex

nuts (See Figure 3-9.)

b. Connect 1/2 x 4 x 26 twisted shovels to each

shank using 1/2-13 x 3 plow bolts, flat washer (in

bottom hole only), split lock washers, and hex

nuts. See Figures 2-1 thru 2-16 for

recommended locations of right hand and left

hand shovels.

IMPORTANT

Right and left twisted shovels are determined by

direction of dirt flow when facing the direction of

travel.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 97 98

Pas de commentaire

Landoll 2131 Wing Coulter Chisel Manuel d'utilisateur Page 52