Landoll 6230 Disc Manuel d'utilisateur télécharger pdf (Page 43)

ASSEMBLY INSTRUCTIONS

3-17

Center Frame Tires

1. Install the tire and wheel assemblies on the center

section.

Disc Gangs



DANGER

1. Attach the disc gang assemblies to the center section

using 3/4-10 x 2 grade 8 hex head cap screws and

hex lock nuts (See Figure 3-9.) Use a 3/4-10 x 2-1/2

grade 8 hex head cap screw, manifold mounting

bracket, and hex lock nut on the center front screw of

the right front gang for all sizes.

2. 21’, 23’, and 29’ models require a 3/4-10 x 2-1/2

grade 8 hex head cap screw, manifold mounting

bracket, and hex lock nut at the back hole of the

center right rear gang.

3. On 30’-36’ models, use 3/4-10 x 2-1/2 grade 8 hex

head cap screws at the center of each left front gang.

4. Insert plastic flange bearings into each end of round

tube ends of the center and wing frame disc gang

assemblies.

5. Install a 1/2 x 2-1/4 grooved alloy pin in the end of

each hinge pin.

6. Assemble each wing gang to the center frame gang

using the hinge pin, 1-1/2 thrust washer, 1” washers,

and 1-8 hex lock nut.

NOTE

The thrust washer is positioned on the front side of the

hinge on the front gangs, and on the rear side of the

hinge on the rear gangs.

7. Place the outer ends of the gang bars on stands so

the wing gangs are level with the center section.

Disc blades are extremely sharp. Exercise

extreme care when working on or near disc

blades. Do not allow discs to roll over or fall onto

any bodily part. Do not allow wrenches to slip

when working near disc blades. Never push

wrenches toward disc blades. Do not climb over

machine above disc blades. Failure to stay clear

of disc blade edges can cause serious personal

injury or death.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 95 96

Commentaires sur ces manuels

Pas de commentaire

Landoll 6230 Disc Manuel d'utilisateur Page 43

Commentaires sur ces manuels

Produits connexes et manuels pour Machines spéciales Landoll 6230 Disc